LED controller, BLACKWATER+SWAN+12 CONTROLLER 6A
- LED controller for operation at 12/24 V DC
- Maximum connected load specified: 216–432 W
- Compact dimensions of just 5.3 x 6 x 2.3 cm
- IP20: for dry indoor areas, with no water protection
Pay easily and securely.
Same-day dispatch from our EU warehouse.
For consumers, under our withdrawal policy.
LED controller, BLACKWATER+SWAN+12 CONTROLLER 6A
In an LED installation, the controller must match the electrical design. BLACKWATER+SWAN+12 CONTROLLER 6A is an LED controller for 12/24 V DC. It is therefore intended for a DC supply, not for direct connection to mains voltage.
Understanding the connected load
The maximum connected load is specified as 216–432 W. This value describes the permissible connected load, not the controller’s own power consumption. When configuring the installation, both the correct operating voltage and the power of the connected LED devices are therefore important. Compare these specifications with your planned installation before making your selection.
Space requirements and installation environment
The controller’s dimensions of 5.3 x 6 x 2.3 cm allow you to plan precisely how much space it needs. Check the intended installation location against these dimensions, especially where space is limited.
Protection rating IP20 provides no water protection. A dry indoor area is therefore the appropriate environment for this controller. The three practical points to consider are the 12/24 V DC supply, the maximum connected load and the available space.
This controller controls RGB LED strips with an IR remote control.
- Product type
- LED controller
- Model
- BLACKWATER+SWAN+12 CONTROLLER 6A
- Operating voltage
- 12/24 V DC
- Dimensions
- 53 x 60 x 23 mm
- IP rating
- IP20
- Maximum connected load
- 216 W-432 W
- Bulb included
- Not applicable
- Control
- IR remote control
feedback Report comment